Home > Plastics > Materials > Styrolution PS > Styrolution PS 124N/L - Datasheet

Styrolution PS 124N/L Data Sheet

General Purpose Polystyrene

Supplied by Styrolution

View Complete Data Sheet Search 96000+ Data Sheets
Create Your Free Account!
Product Description
Styrolution PS 124N/L is a general purpose polystyrene grade with a good flow characteristic and an improved heat resistance.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Europe
 
Features 
  • Food Contact Acceptable
  • General Purpose
  • Good Flow
  • High Heat Resistance
 
Uses 
  • Blending
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Melt Volume-Flow Rate (MVR) (200°C/5.0 kg)
in³/10min
ISO 1133
Molding Shrinkage
%
ISO 294-4
Water Absorption
    ISO 62
Saturation, 73°F
%
 
Equilibrium, 73°F, 50% RH
%
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ISO 527-2
Tensile Stress (Yield, 73°F)
psi
ISO 527-2
Nominal Tensile Strain at Break
%
ISO 527-2
Flexural Strength
psi
ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength (73°F)
ft·lb/in²
ISO 179
Hardness
Nominal Value
Unit
Test Method
Ball Indentation Hardness
psi
ISO 2039-1
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (264 psi, Annealed)
°F
ISO 75-2/A
Vicat Softening Temperature
°F
ASTM D1525 2
CLTE - Flow
in/in/°F
ISO 11359-2
Thermal Conductivity
Btu·in/hr/ft²/°F
DIN 52612
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohm
IEC 60093
Volume Resistivity
ohm·cm
IEC 60093
Flammability
Nominal Value
Unit
Test Method
Flame Rating 3
 
UL 94
Features
Features may also be described by the following terms: Good Flow, High Heat Resistance.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EU (1).
Available Documents
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
 
Notes
1Typical properties: these are not to be construed as specifications.
2Rate B (120°C/h), Loading 2 (50 N)
3Antwerp Only
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.