| General | |
|
Material Status
|
|
|
Availability
|
|
|
Uses
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
|
|
g/10 min
|
ASTM D1238 |
| Mechanical |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Elongation 2 (Break, 0.000984 in)
|
|
%
|
ASTM D2101 |
| Additional Information |
Nominal Value
|
Unit
|
Test Method
|
|
Tenacity of Fibers - at Break
|
ASTM D2101 | ||
|
1.0 mil 3
|
|
g/denier
|
|
|
1.0 mil 4
|
|
g/denier
|
|
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Jam PE 36XF6, Jam PE , JamPE36XF6, JamPE, PE 36 XF 6, PE36XF6, PE36, PE, 36 XF 6, 36XF6, 36XF, XF6, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, Jam Petrochemical, PolyethyleneHighDensity, XF36, 36PE
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
| 2Blown Film |
| 3Blown Film, 3500 denier strap,stretch ratio 1:8 |
| 4Blown Film, 480 denier monofilament , stretch ratio 1:8.3 |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |