| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Processing Method
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
|
|
g/10 min
|
ASTM D1238 |
|
Environmental Stress-Cracking Resistance
|
|
hr
|
No Standard |
|
Flow Rate Ratio
|
|
|
ASTM D1238 |
| Mechanical |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Strength
|
ASTM D638 | ||
|
Yield, Compression Molded
|
|
psi
|
|
|
Break, Compression Molded
|
|
psi
|
|
|
Tensile Elongation (Break, Compression Molded)
|
|
%
|
ASTM D638 |
|
Flexural Modulus (Compression Molded)
|
|
psi
|
ASTM D790 |
| Impact |
Nominal Value
|
Unit
|
Test Method
|
|
Notched Izod Impact (73°F)
|
|
|
ASTM D256A |
| Thermal |
Nominal Value
|
Unit
|
Test Method
|
|
Vicat Softening Temperature
|
|
°F
|
ASTM D1525 |
| Optical |
Nominal Value
|
Unit
|
Test Method
|
|
Yellowness Index
|
|
YI
|
ASTM D1925 |
| Additional Information |
Nominal Value
|
Unit
|
Test Method
|
|
Titanium
|
|
ppm
|
|
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Jam PE 30Y04, Jam PE , JamPE30Y04, JamPE, PE 30 Y 04, PE30Y04, PE30, PE, 30 Y 04, 30Y04, 30Y, Y04, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, Jam Petrochemical, PolyethyleneLinearLowDensity, Y30, 30PE
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |