Home > Plastics > Materials > INSULCAST® > INSULCAST® 136/INSULCURE 11B - Datasheet

INSULCAST® 136/INSULCURE 11B Data Sheet

Epoxy; Epoxide

Supplied by ITW Polymers Coatings North America

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
INSULCAST 136 is an easy to use epoxy casting/potting compound exhibiting excellent adhesion to metals, ceramics and most plastics. When properly cured with INSULCURE 11B, INSULCAST 136 will conform to the requirements of MIL-I-16923, Types B, C & D, and will not support fungus growth.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Fungus Resistant
  • General Purpose
  • Good Adhesion
Uses 
  • General Purpose
Agency Ratings 
Processing Method 
  • Casting
  • Potting
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Strength
psi
ASTM D790
Compressive Strength
psi
ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Heat Deflection Temperature
°F
 
Service Temperature
°F
 
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
ASTM D257
Dielectric Strength
V/mil
ASTM D149
Dielectric Constant (1 kHz)
 
ASTM D150
Dissipation Factor (1 kHz)
 
ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
     
Hardener
 
 
Resin
 
 
Shelf Life
wk
 
Post Cure Time (302°F)
hr
 
Features
Features may also be described by the following terms: Good Adhesion.
Agency Ratings
This plastic material has 3 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): MIL (3).
Available Documents
Technical Datasheet (English)
Uncured Properties
Nominal Value
Unit
Test Method
Color
     
-- 2
 
 
-- 3
 
 
Density
     
-- 2
g/cm³
 
-- 3
g/cm³
 
Viscosity
    ASTM D2393
-- 2
Pa·s
 
-- 4
Pa·s
 
-- 3
Pa·s
 
Pot Life (77°F)
min
 
Curing Time (212°F)
hr
 
Cured Properties
Nominal Value
Unit
Test Method
Linear Shrinkage
mil/in
 
Notes
1Typical properties: these are not to be construed as specifications.
2INSULCURE 11B
3INSULCAST 136
4Mixed
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.