Tepex® dynalite 207-C200(x)/50%3K Carbon - PPS consolidated composite laminate The datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

30% Glass Reinforced, High Impact, Food Contact Quality, Drinking Water Grade Design Challenge Degradation & Stability | Chemical stability

30% Glass Reinforced, Drinking Water Grade, Food Contact Quality, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

30% Glass Reinforced, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

30% Glass Reinforced, Flame Retardant, Excellent Mold Release, Low Flash Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Improved Impact Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Flame Retardant, Improved flow Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Wear and Friction Modified, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Halogen free, Chlorine Content < 900 ppm Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Drinking Water Grade, Food Contact Quality, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Excellent Mold Release, Flame Retardant

40% Glass Reinforced, Excellent Mold Release, Flame Retardant Design Challenge Degradation & Stability | Chemical stability

40% Glass Reinforced, Flame Retardant, Hydrolysis resistant Design Challenge Degradation & Stability | Chemical stability

Design Challenge Degradation & Stability | Chemical stability

Flame Retardant, Enhanced Mechanical Strength, Excellent Dimensional Stability Design Challenge Degradation & Stability | Chemical stability

65% Glass/Mineral Reinforced, Flame Retardant, Excellent Dimensional Stability Design Challenge Degradation & Stability | Chemical stability

Thermal conductive material Design Challenge Degradation & Stability | Chemical stability

Unreinforced, Extrusion Design Challenge Degradation & Stability | Chemical stability

Extrusion, Improved Impact Despite the fact that the above-mentioned grade is an extrusion grade, when using it for an injection molding process, the document below describes the typical injection molding recommendations. Design Challenge Degradation & Stability | Chemical stability