| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Filler / Reinforcement
|
|
|||
|
Features
|
|
|||
|
Uses
|
|
|||
|
Forms
|
|
|||
|
Processing Method
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Density
|
|
g/cm³
|
ISO 1183 |
|
Molding Shrinkage - Flow
|
|
%
|
ISO 294-4 |
| Mechanical |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Modulus
|
|
psi
|
ISO 527-2 |
|
Tensile Stress (Yield)
|
|
psi
|
ISO 527-2 |
|
Tensile Strain (Break)
|
|
%
|
ISO 527-2 |
|
Flexural Modulus
|
|
psi
|
ISO 178 |
| Additional Information | |||
|
Notched Izod Impact Strength, ISO 180, Notch A: 6 KJ/m
|
|||
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Ecomass® 4301TU74, Ecomass 4301TU74, Ecomass® , Ecomass, Ecomass4301TU74, 4301 TU 74, 4301TU74, 4301TU, TU74, Polyphthalamide, PPA, Polyamide, Nylon, TU4301
|
|||
| Features | |||
|
Features may also be described by the following terms: Good Toughness, Tough, Medium Rigidity, Good Rigidity, Non-Toxic, Non Toxic, Toxicity None.
|
|||
| Injection |
Nominal Value
|
Unit
|
|
|
Drying Temperature
|
|
°F
|
|
|
Drying Time
|
|
hr
|
|
|
Suggested Max Moisture
|
|
%
|
|
|
Processing (Melt) Temp
|
|
°F
|
|
|
Mold Temperature
|
|
°F
|
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |