| General | |
|
Material Status
|
|
|
Availability
|
|
|
Appearance
|
|
|
Forms
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Specific Gravity
|
|
|
ASTM D792 |
| Elastomers |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Stress (100% Strain)
|
|
psi
|
ASTM D412 |
|
Tensile Strength (Yield)
|
|
psi
|
ASTM D412 |
|
Tensile Elongation (Break)
|
|
%
|
ASTM D412 |
|
Tear Strength
|
|
lbf/in
|
ASTM D624 |
| Hardness |
Nominal Value
|
Unit
|
Test Method
|
|
Durometer Hardness (Shore A)
|
|
|
ASTM D2240 |
| Thermoset |
Nominal Value
|
Unit
|
Test Method
|
|
Post Cure Time (302°F)
|
|
hr
|
|
| Additional Information | |||
|
Viscosity, Part A: 500 Pa.s
Viscosity, Part B: 500 Pa.s Cure Rate, ODR, 302°F, T10: 31 sec Cure Rate, ODR, 302°F, T90: 38 sec Press Cure, 5 min at 302°F |
|||
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM KE2000-40, Shincor LIM KE200040, Shincor LIM , ShincorLIMKE200040, ShincorLIM, KE 2000, LIMKE 2000 40, LIMKE 2000, LIMKE2000-40, LIMKE200040, LIMKE2000:40, LIMKE2000/40, LIMKE2000+40, LIMKE2000_40, LIMKE2000 40, LIMKE2000, KE 2000 40, KE2000-40, KE200040, KE2000:40, KE2000/40, KE2000+40, KE2000_40, KE2000 40, KE2000, 200040, Silicone, Shincor Sil, 2000KE, 2000LIMKE
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |