Home > Plastics > Materials > Braskem PE > Braskem PE BC-818 - Datasheet

Braskem PE BC-818 Datasheet

Low Density Polyethylene

Supplied by Braskem

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
Description:
BC818 is a grade produced under high pressure in an autoclave reactor. In the coating process it presents very good optical properties, low neck-in, good film stability, and good adhesion on porous substrate. Without additives.

Applications:
Extrusion coating; injection of general parts and carrier for masterbatches.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • Latin America
 
Features 
  • Autoclavable
  • Good Adhesion
  • Low Neck-In
  • Opticals
  • Porous
Uses 
  • Coating Applications
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Extrusion Coating
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
 
Tensile Strength
    ASTM D882
MD : Break
psi
 
TD : Break
psi
 
Tensile Elongation
    ASTM D882
MD : Break
%
 
TD : Break
%
 
Flexural Modulus - 1% Secant, MD
psi
ASTM D790
Dart Drop Impact
g
ASTM D1709
Elmendorf Tear Strength - TD
g
ASTM D1922
Optical
Nominal Value
Unit
Test Method
Gloss (60°)
 
ASTM D2457
Haze
%
ASTM D1003
Features
Features may also be described by the following terms: Autoclavable, Autoclave, Good Adhesion, Low Neck-in, Low Neck In.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Available Documents
Technical Datasheet (English)
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
 
Cylinder Zone 2 Temp.
°F
 
Cylinder Zone 3 Temp.
°F
 
Cylinder Zone 4 Temp.
°F
 
Cylinder Zone 5 Temp.
°F
 
Extrusion Notes
Screw W/D ratio 20:1
Compression ratio 3 to 4:1
Notes
1Typical properties: these are not to be construed as specifications.
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.