| Product Description | |
|
ALKAMIX MB6010 is a processing aid masterbatch based on a fluoropolymer compound at a concentration of 10 percent.
ALKAMIX MB6010 can be added to linear low density polyethylene (LLDPE) during extrusion to eliminate melt fracture (Sharkskin) type extrusion defects. The level required will vary according to extrusion equipment and type of LLDPE being used, however the recommended addition level is between 0.5 and 1 percent. ALKAMIX MB6010 is compatible with the process aid used in Alkatuff film polymers. The maximum level of addition of MB6010 based on both good manufacturing practice and to ensure conformance to the requirements to the United States Food and Drug Administration Regulations CFR21 is 2.5 percent, when added to a polyethylene formulation free of any other additives. |
|
| General | |
|
Material Status
|
|
|
Availability
|
|
|
Uses
|
|
|
Forms
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Density
|
|
g/cm³
|
ASTM D1505 |
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALKAMIX™ MB6010, ALKAMIX MB6010, ALKAMIX™ , ALKAMIX, ALKAMIXMB6010, MB 6010, MB6010, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Qenos, PolyethyleneLinearLowDensity, 6010MB
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |