| Product Description | ||||
|
ALKAMIX MB6005 is a combined slip and antiblock masterbatch based on a linear low density polyethylene carrier. It is formulated with slip additive (Erucamide) at a concentration of 8 percent and antiblock additive at a concentration of 25 percent.
ALKAMIX MB6005 can be added to linear low density polyethylene (LLDPE) during extrusion to reduce film blocking and coefficient of friction. The level required will vary according to desired properties and presence of any other additives, however the recommended addition level is between 1 and 2 percent. The maximum level of addition of MB6005 based on both good manufacturing practice and to ensure conformance to the requirements to the United States Food and Drug Administration Regulations CFR21 is 2.5 percent, when added to a polyethylene formulation free of any other additives. |
||||
| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Additive
|
|
|||
|
Features
|
|
|||
|
Uses
|
|
|||
|
Forms
|
|
|||
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALKAMIX™ MB6005, ALKAMIX MB6005, ALKAMIX™ , ALKAMIX, ALKAMIXMB6005, MB 6005, MB6005, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Qenos, PolyethyleneLinearLowDensity, 6005MB
|
|||
| Features | |||
|
Features may also be described by the following terms: Antiblocking, Unspecified Antiblock, Slip, Unspecified Slip.
|
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |