| Product Description | ||||
|
PP 30% Talc
|
||||
| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Filler / Reinforcement
|
|
|||
|
Automotive Specifications
|
|
|||
|
Processing Method
|
|
|||
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Specific Gravity
|
|
|
ASTM D792 |
|
Molding Shrinkage - Flow 2
|
|
in/in
|
Internal Method |
| Mechanical |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Strength 3 (Yield)
|
|
psi
|
ASTM D638 |
|
Flexural Modulus 4
|
|
psi
|
ASTM D790 |
| Impact |
Nominal Value
|
Unit
|
Test Method
|
|
Notched Izod Impact
|
|
ft·lb/in
|
ASTM D256 |
| Thermal |
Nominal Value
|
Unit
|
Test Method
|
|
Deflection Temperature Under Load
|
ASTM D648 | ||
|
66 psi, Unannealed
|
|
°F
|
|
|
264 psi, Unannealed
|
|
°F
|
|
| Additional Information |
Nominal Value
|
Unit
|
Test Method
|
|
Filler Content
|
|
%
|
ASTM D5630 |
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: POLYFORT® FPP 1607, POLYFORT FPP 1607, POLYFORT® , POLYFORT, POLYFORTFPP1607, FPP 1607, FPP1607, Polypropylene, Unspecified, Polypropylene Unspecified, PP, Unspecified, PP Unspecified, Polypropylene, PP, A. Schulman, PolypropyleneUnspecified, PPUnspecified, 1607FPP
|
|||
| Generic Name | |||
|
Generic Name may also be described by the following terms: Polypropilene, Polypropelene.
|
|||
| Automotive Specifications | |||
|
This plastic material has approval for 2 automotive specifications from the following agencies (the number in parentheses shows the number of specifications for that agency): NISSAN (1), TOYOTA (1).
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
| 25x7 in plaque |
| 32.0 in/min |
| 40.051 in/min |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |