| Product Description | |
|
This material is compounded for use in HAV systems. It can also be cured with Cadox TS-50.
Catalyzed with 0.5 parts Shin-Etsu C-19A and 2.4 parts Shin-Etsu C-19B. Press cured 10 min. @ 165°C. Post cured 4 hrs. @ 200°C. Pot life is 48~72 hrs. after the compound is mixed with C-19A and C-19B. |
|
| General | |
|
Material Status
|
|
|
Availability
|
|
|
Uses
|
|
|
Appearance
|
|
|
Forms
|
|
|
Processing Method
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Specific Gravity
|
|
|
ASTM D792 |
| Elastomers |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Strength (Yield)
|
|
psi
|
ASTM D412 |
|
Tensile Elongation (Break)
|
|
%
|
ASTM D412 |
|
Tear Strength
|
|
lbf/in
|
ASTM D624 |
|
Compression Set (356°F)
|
|
%
|
ASTM D395 |
| Hardness |
Nominal Value
|
Unit
|
Test Method
|
|
Durometer Hardness (Shore A)
|
|
|
ASTM D2240 |
| Thermoset |
Nominal Value
|
Unit
|
Test Method
|
|
Pot Life
|
|
min
|
|
|
Demold Time (329°F)
|
|
min
|
|
|
Post Cure Time (392°F)
|
|
hr
|
|
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM KE-1741 U, Shincor LIM KE1741 U, Shincor LIM , ShincorLIMKE1741U, ShincorLIM, KE, LIMKE-1741 U, LIMKE1741 U, LIMKE:1741 U, LIMKE/1741 U, LIMKE+1741 U, LIMKE_1741 U, LIMKE 1741 U, LIMKE1741, LIMKE, LIMKE1741U, KE-1741 U, KE1741 U, KE:1741 U, KE/1741 U, KE+1741 U, KE_1741 U, KE 1741 U, KE1741, 1741U, LIMKE_1741U, KE1741U, KE_1741U, Silicone, Shincor Sil, 1741KE, 1741LIMKE
|
|||
| Uses | |||
|
Uses may also be described by the following terms: Tubing, Tube.
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |