| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Features
|
|
|||
|
Uses
|
|
|||
|
Appearance
|
|
|||
|
Forms
|
|
|||
|
Processing Method
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Specific Gravity
|
|
|
ASTM D792 |
| Elastomers |
Nominal Value
|
Unit
|
Test Method
|
|
Tensile Strength (Yield)
|
|
psi
|
ASTM D412 |
|
Tensile Elongation (Break)
|
|
%
|
ASTM D412 |
|
Tear Strength
|
|
lbf/in
|
ASTM D624 |
|
Compression Set (356°F)
|
|
%
|
ASTM D395 |
| Hardness |
Nominal Value
|
Unit
|
Test Method
|
|
Durometer Hardness (Shore A)
|
|
|
ASTM D2240 |
| Thermoset |
Nominal Value
|
Unit
|
Test Method
|
|
Thermoset Components
|
|||
|
Hardener
|
|
|
|
|
Resin
|
|
|
|
|
Pot Life (77°F)
|
|
min
|
|
|
Shelf Life (90°F)
|
|
wk
|
|
|
Thermoset Mix Viscosity
|
|
cP
|
ASTM D2393 |
|
Demold Time (248°F)
|
|
min
|
|
|
Post Cure Time (302°F)
|
|
hr
|
|
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Shincor LIM KE-1984, Shincor LIM KE1984, Shincor LIM , ShincorLIMKE1984, ShincorLIM, KE, LIMKE-1984, LIMKE1984, LIMKE:1984, LIMKE/1984, LIMKE+1984, LIMKE_1984, LIMKE 1984, LIMKE, KE-1984, KE1984, KE:1984, KE/1984, KE+1984, KE_1984, KE 1984, Silicone, Shincor Sil, 1984KE, 1984LIMKE
|
|||
| Features | |||
|
Features may also be described by the following terms: Fast Cure, Fast Curing, Heat Cure, Good Tear Strength.
|
|||
| Uses | |||
|
Uses may also be described by the following terms: Closure Caps, Caps, Cap, Gaskets, Gasketing, Conveyor Parts, Conveyor Components.
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |