| General | ||||
|
Material Status
|
|
|||
|
Availability
|
|
|||
|
Features
|
|
|||
|
Uses
|
|
|||
|
Processing Method
|
|
| Physical |
Nominal Value
|
Unit
|
Test Method
|
|
Density
|
|
g/cm³
|
ASTM D1505 |
|
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
|
|
g/10 min
|
ASTM D1238 |
| Films |
Nominal Value
|
Unit
|
Test Method
|
|
Film Thickness - Tested
|
|
mil
|
|
|
Tensile Strength
|
ASTM D882 | ||
|
MD: Yield, 0.98 mil, Blown Film
|
|
psi
|
|
|
TD: Yield, 0.98 mil, Blown Film
|
|
psi
|
|
|
MD: Break, 0.98 mil, Blown Film
|
|
psi
|
|
|
TD: Break, 0.98 mil, Blown Film
|
|
psi
|
|
|
Tensile Elongation
|
ASTM D882 | ||
|
MD: Break, 0.98 mil, Blown Film
|
|
%
|
|
|
TD: Break, 0.98 mil, Blown Film
|
|
%
|
|
|
Dart Drop Impact (0.98 mil, Blown Film)
|
|
g
|
ASTM D1709A |
|
Elmendorf Tear Strength
|
ASTM D1922 | ||
|
MD: 0.98 mil, Blown Film
|
|
g
|
|
|
TD: 0.98 mil, Blown Film
|
|
g
|
|
| Optical |
Nominal Value
|
Unit
|
Test Method
|
|
Gloss (45°, 0.984 mil, Blown Film)
|
|
|
ASTM D1790 |
|
Haze (0.984 mil, Blown Film)
|
|
%
|
ASTM D1003 |
| Related Terminology | |||
|
Product names can be difficult to match. You may have searched any one of these terms to find this product: Jam PE 16503, Jam PE , JamPE16503, JamPE, PE 16503, PE16503, PE, 16503, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, Jam Petrochemical, PolyethyleneLinearLowDensity, 16503PE
|
|||
| Features | |||
|
Features may also be described by the following terms: Butene Comonomer.
|
|||
| Uses | |||
|
Uses may also be described by the following terms: Cast Film.
|
|||
| Notes |
| 1Typical properties: these are not to be construed as specifications. |
|
UL and the UL logo are trademarks of UL LLC © 2013. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier. |