Home > Plastics > Materials > INSULCAST® > INSULCAST® 333/INSULCURE 11B - Datasheet

INSULCAST® 333/INSULCURE 11B Data Sheet

Epoxy; Epoxide

Supplied by ITW Polymers Coatings North America

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
INSULCAST 333 is a moderate viscosity, self-extinguishing, epoxy potting/casting compound which conforms to the component program of Underwriters Laboratories' Flame Class 94V-O.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Medium Viscosity
  • Self Extinguishing
 
Processing Method 
  • Casting
  • Potting
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Strength
psi
ASTM D790
Compressive Strength
psi
ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Heat Deflection Temperature
°F
 
Service Temperature
°F
 
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
ASTM D257
Dielectric Strength
V/mil
ASTM D149
Dielectric Constant (1 kHz)
 
ASTM D150
Dissipation Factor (1 kHz)
 
ASTM D150
Flammability
Nominal Value
Unit
Test Method
Flame Rating
 
UL 94
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
     
Hardener
 
 
Resin
 
 
Shelf Life (77°F)
wk
 
Post Cure Time (302°F)
hr
 
Features
Features may also be described by the following terms: Medium Viscosity, Self Extinguishing, Self-Extinguishing.
Available Documents
Technical Datasheet (English)
Uncured Properties
Nominal Value
Unit
Test Method
Color
     
-- 2
 
 
-- 3
 
 
Density
     
-- 2
g/cm³
 
-- 3
g/cm³
 
Viscosity
    ASTM D2393
77°F 2
Pa·s
 
-- 4
Pa·s
 
77°F 3
Pa·s
 
Pot Life 5 (77°F)
min
 
Curing Time
     
212°F 6
hr
 
-- 7
hr
 
Notes
1Typical properties: these are not to be construed as specifications.
2INSULCURE 11B
3INSULCAST 333
4Mixed
5100 gram mass
6for masses less than 1/2 lb.
72 hours at 80°C plus 2 hours at 100°C (for masses above 1/2 lb.)
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.