Home > Plastics > Materials > INSULCAST® > INSULCAST® 125/INSULCURE 9 - Datasheet

INSULCAST® 125/INSULCURE 9 Data Sheet

Epoxy; Epoxide

Filler

Supplied by ITW Polymers Coatings North America

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
INSULCAST 125 is a low viscosity, general purpose potting and casting compound. The low viscosity enables it to be used in potting densely packed modules, thereby insuring good flow and penetration around components. INSULCAST 125 contains non-abrasive fillers and is suitable for automatic dispensing equipment.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Filler
Features 
  • General Purpose
  • Good Flow
  • Low Viscosity
Uses 
  • General Purpose
Processing Method 
  • Casting
  • Potting
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Strength
psi
ASTM D790
Compressive Strength
psi
ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Heat Deflection Temperature
°F
 
Service Temperature
°F
 
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
ASTM D257
Dielectric Strength
V/mil
ASTM D149
Dielectric Constant (1 kHz)
 
ASTM D150
Dissipation Factor (1 kHz)
 
ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
     
Hardener
 
 
Resin
 
 
Shelf Life (77°F)
wk
 
Features
Features may also be described by the following terms: Low Viscosity, Good Flow.
Available Documents
Technical Datasheet (English)
Uncured Properties
Nominal Value
Unit
Test Method
Color
     
-- 2
 
 
-- 3
 
 
Density
    ASTM D1475
-- 2
g/cm³
 
-- 3
g/cm³
 
Viscosity
     
-- 2
Pa·s
 
77°F 4
Pa·s
 
-- 3
Pa·s
 
Pot Life 5 (77°F)
min
 
Curing Time (77°F)
hr
 
Notes
1Typical properties: these are not to be construed as specifications.
2INSULCURE 9
3INSULCAST 125
4Mixed
5100 gram mass
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.