Home > Plastics > Materials > INSULCAST® > INSULCAST® 118 FC - Datasheet

INSULCAST® 118 FC Data Sheet

Epoxy; Epoxide

Supplied by ITW Polymers Coatings North America

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
INSULCAST 118 FC is an equal ratio by weight of volume epoxy potting/casting compound designed for dispensing equipment. INSULCAST 118 FC exhibits good impact strength and mechanical shock resistance.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Impact Resistance
  • Shock Resistant
 
Processing Method 
  • Casting
  • Potting
 
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Compressive Strength
psi
ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 
Thermal Conductivity
Btu·in/hr/ft²/°F
 
Service Temperature
°F
 
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
ASTM D257
Dielectric Strength
V/mil
ASTM D149
Dielectric Constant (1 kHz)
 
ASTM D150
Dissipation Factor (1 kHz)
 
ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
     
Part A
 
 
Part B
 
 
Shelf Life (77°F)
wk
 
Features
Features may also be described by the following terms: Good Impact Resistance.
Available Documents
Technical Datasheet (English)
Uncured Properties
Nominal Value
Unit
Test Method
Color
     
-- 2
 
 
-- 3
 
 
Density
     
-- 2
g/cm³
 
-- 3
g/cm³
 
Viscosity
    ASTM D2393
-- 2
Pa·s
 
-- 4
Pa·s
 
-- 3
Pa·s
 
Pot Life (77°F)
min
 
Curing Time (77°F)
hr
 
Notes
1Typical properties: these are not to be construed as specifications.
2Part A
3Part B
4Mixed
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.