Home > Plastics > Materials > ICORENE® > ICORENE® CX-350S - Datasheet

ICORENE® CX-350S Data Sheet

Crosslinked Polyethylene

Supplied by ICO Polymers NA, A Division of A. Schulman

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
ICORENE® CX-350S is a cross-linkable, semi-conductive polyolefin compound.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antistatic
  • UV Stabilizer
 
Features 
  • Antistatic
  • Crosslinkable
  • Good UV Resistance
  • High Flow
  • Low Warpage
  • Semi Conductive
  • Ultra High Toughness
Appearance 
  • Black
Forms 
  • Powder
Processing Method 
  • Rotational Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
ISO 527-2
Flexural Modulus - 1% Secant
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Low Temperature Impact (0.13 in)
ft·lb/in
ARM
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
ASTM D2240
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohm
IEC 61340-2-3
Volume Resistivity
ohm·cm
IEC 61340-2-3
Surface Resistance (0.13 in)
 
IEC 61340-2-3
Additional Information
Nominal Value
Unit
Test Method
Volume Resistance (0.13 in)
ohm
IEC 61340-2-3
Features
Features may also be described by the following terms: Low Warpage, Low Warp, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Semi-Conductive, Semi Conductive, High Flow, High Melt, High MFI, Ultra High Toughness.
Notes
1Typical properties: these are not to be construed as specifications.
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.