Home > Plastics > Materials > 4LOY® > 4LOY® 10E17100 - Datasheet

4LOY® 10E17100 Data Sheet

Acrylonitrile Butadiene Styrene + PC

Supplied by 4Plas

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
4LOY® 10E17100 is an Acrylonitrile Butadiene Styrene + PC (ABS+PC) product. It can be processed by injection molding and is available in Europe. Primary characteristic: flame retardant/flame rated.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Melt Mass-Flow Rate (MFR)
g/10 min
ISO 1133
Molding Shrinkage - Flow
%
ISO 2557
Water Absorption (Saturation, 73°F)
%
ISO 62
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus (73°F)
psi
ISO 527-2
Tensile Stress
    ISO 527-2
Yield, 73°F
psi
 
Break, 73°F
psi
 
Tensile Strain
    ISO 527-2
Yield, 73°F
%
 
Break, 73°F
%
 
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength
    ISO 180/1A
-22°F
ft·lb/in²
 
73°F
ft·lb/in²
 
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature
     
66 psi, Unannealed
°F
ISO 75-2/B
264 psi, Unannealed
°F
ISO 75-2/A
Vicat Softening Temperature
°F
ISO 306/B
Flammability
Nominal Value
Unit
Test Method
Flame Rating
    UL 94
0.0630 in
 
 
0.126 in
 
 
Glow Wire Ignition Temperature (0.0787 in)
°F
IEC 60695-2-13
Available Documents
Processing - 4Plas 4LOY (English)
Processing (English)
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Suggested Max Regrind
%
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Injection Notes
Back Pressure: Low
Injection Pressure: High
Notes
1Typical properties: these are not to be construed as specifications.
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL IDES from the producer of the material. UL IDES makes substantial efforts to assure the accuracy of this data. However, UL IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.