Home > Plastics > Materials > OP - ABS > OP - ABS ABS 4-8 SS - Datasheet

OP - ABS ABS 4-8 SS Data Sheet

Acrylonitrile Butadiene Styrene

8.0% Stainless Steel Fiber

Supplied by Oxford Polymers

View Complete Data Sheet Search 95000+ Data Sheets
Create Your Free Account!
Product Description
EMI / ESD SHIELDING
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Stainless Steel Fiber, 8.0% Filler by Weight
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/3.8 kg)
g/10 min
ASTM D1238
Molding Shrinkage - Flow
in/in
ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
    ASTM D638
Yield
psi
 
Break
psi
 
Flexural Modulus
psi
ASTM D790
Flexural Strength
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (40°F)
ft·lb/in
ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
    ASTM D648
66 psi, Unannealed, 0.125 in
°F
 
264 psi, Unannealed, 0.125 in
°F
 
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohm
ASTM D257
Flammability
Nominal Value
Unit
Test Method
Flame Rating
    UL 94
0.0625 in
 
 
0.125 in
 
 
Additional Information
Melt Mass- Flow Rate (MFR), ASTM D1238, 230°C/ 3.8kg: 3 to 8 g/10 min
Surface Resitivity, ASTM D257: 1E1 to 1E3 ohms
Available Documents
Technical Datasheet (English)
Injection
Nominal Value
Unit
 
Drying Temperature
°F
 
Drying Time
hr
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Notes
1Typical properties: these are not to be construed as specifications.
 
UL and the UL logo are trademarks of UL LLC © 2014. All Rights Reserved.
The information presented on this datasheet was acquired by UL Prospector from the producer of the material. UL Prospector makes substantial efforts to assure the accuracy of this data. However, UL Prospector assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.